Instructions for talking watch

Instructions for Using a Xinjia Talking Watch

Initial Setup

1. Remove the watch from packaging and locate the instruction manual
2. Insert battery (if not pre-installed) – usually a button cell battery
3. Set the time by pressing and holding the appropriate buttons (typically the mode and set buttons simultaneously)

Basic Functions

Time Announcement

• Press the top right button (usually labeled “TALKING” or “TIME”) to hear the current time
• The watch will announce the time in a clear voice

Setting the Time

1. Press and hold the MODE button
2. When the time is flashing in the screen:
   1. Use the HOUR button to adjust hours (If you see a small P on the left side of the screen, that means PM (afternoon/night)
   2. Press MODE to move to minutes
   3. Use MINUTE button to adjust minutes
   4. Press MODE to confirm and setup the alarm

Setting Alarms

1. Press MODE button to cycle to alarm mode
2. Once you setted up the time and witthe time is flashing in the screen, but now you will setup the alarm.
   1. Use the HOUR button to adjust hours (If you see a small P on the left side of the screen, that means PM (afternoon/night)
   2. Press MODE to move to minutes
   3. Use MINUTE button to adjust minutes
   4. Press MODE to confirm and setup the alarm

Troubleshooting

• No sound: Check battery
• Wrong time: Reset following time-setting steps
• Unclear speech: Replace battery or check for damage

Note: Button locations may vary by model. Refer to your specific model’s manual for exact button positions.